The RAT Works Carbon Shroud - Gamo

The RAT Works Carbon Fibre Shroud.

These bespoke carbon fibre shrouds are not only stunning to look at, they are lightweight, perform exceptionally well and are extremely quiet due to the internal moderator incorporated into the shroud. These are better than any off the shelf moderator.

!! These now include the all new RAT Works Air Stripper !!

THIS ITEM IS BUILT TO ORDER

All shrouds are made to order and are available for either 12, 15 or 18 inch barrels.

This 26mm diameter shroud will fit the air rifles:

- GAMO Coyote
- Gamo Phox
- Gamo GX40
- Gamo Venari
- Gamo GX-250

This may fit other Gamo models but please contact us before ordering

Some Gamo models may require the barrel band removing

All shrouds utilise a flat backed rear bushing, this may leave a slight gap on rifles that feature a sloping front to their breech block.

Please note: To measure your barrel you will need to remove any shroud or moderator parts you currently have fitted to your rifle. Then measure from the magazine inlet (where the pellet enters the barrel) to the end of the threaded section of your barrel (muzzle). Please see photos for a visual guide to measuring your barrel.

Once fitted, our shroud will be the same as the length of your barrel with a standard moderator on. (eg, HW moderator)

Fitting instructions will be supplied.

Please allow 10 working days for us to make your shroud as this item is built to order.

All shrouds must be sold on a face to face basis, either by collection directly from us or from your local RFD/Gun shop, due to the Violent Crime Reduction Act 2006 (VCR Bill) Please make contact with your local RFD and let them know to expect a parcel from us in the next week or so.

If you wish to have your new shroud delivered to your local RFD/Gunshop, please ensure you use their details as your delivery address during the checkout process! 

Shrouds can only be supplied to UK customers. Overseas orders will be cancelled and refunded!

This item is non-cancellable and non-refundable once a paid order has been placed, these items are bespoke and made to order. Fabrication and construction of your shroud will not begin until payment has been made in full.

The shroud requires a 1/2" UNF muzzle thread, some models of Gamo rifle were produced without this, before ordering please ensure your rifle has a 1/2" UNF muzzle thread!

The shroud is however covered by our warranty and guarantee.